Finger Pocket Designer

A mono, duo or three-finger pocket block for lifts and hangs, sized to your fingers. Your measurements stay on this device.

Start here
  1. Pick the fingers (Fingers): the width follows their widths from the Unlevel edge page's hand table; you can still type a width in (Pocket).
  2. Set the pocket: blind (a floor stops the fingertips, like a hangboard pocket) or right through; depth and rim radius like a hangboard pocket.
  3. Check the strength (below the 3D view): safety factor at least 2 at your heaviest pull.
  4. Export and print it flat, no supports. Hang it from the cord; the fingers go in from the rounded face and pull on the bar.

Block

front as it hangs from the cord, and a cut through the middle (thickness across, bed on the left)

Print preview

as printed: flat on the bed · drag to turn, wheel to zoom

Export

The STL is the plain part. The 3MF files also carry layer height, walls, infill and top/bottom layers. PrusaSlicer and OrcaSlicer keep your current printer, nozzle and filament. Bambu Studio only applies the settings when the file names its printer presets, so pick your Bambu printer.